Fane Sovereign 10-300 Fane Sovereign 10-300
TFane Sovereign 10-300 TFane Sovereign 10-300


Bass / Mid Range Driver

Data Sheet
(1 Reviews)  Review this item
  • 600 W Program Power.
  • 97.5 dB Sensitivity (1W/1m).
  • Versatile in 2 way ported enclosures such as the classic bass driver plus horn tweeter or compression driver format.
  • Can be used effectively for bass guitar applications.
  • Exhibits smooth frequency response that gives a balanced tonal character when properly matched to appropriate high-frequency drivers.
  • Best suited for 15-40 Litre ported enclosure designs.
  • 2.5-inch Inside/ outside windings copper voice coil.
  • Please enquire about alternative impedances.
  • A.E.S. power handling test. Pink noise bandpass filtered at 12 dB per octave with cutoff frequencies of 45 Hz and 450 Hz. Driver mounted in free air, test signal applied at rated power for two hours.
  • Please note that the frequency response measurements are supplied for comparison only and are not a measure of the low frequency performance which may be achieved in a fully optimised system.
Electro Acoustic Specifications
Nominal Chassis Diameter 10" / 254 mm
Impedance 4 /8 /16 Ω
Power Handling 300 W (A.E.S.)
Peak Power (6dB Crest Factor) 1200 W (A.E.S.)
Usable Frequency Range (-6dB) 45 Hz - 5 kHz
Sensitivity (1W - 1m) Wideband 97.5 dB
Moving Mass (inc. Air Load) 37 grams
Minimum Impedance (Zmin) 6.8 Ω
Effective Piston Diameter 8.46" / 214.88 mm
Magnet Weight 56 oz
Magnetic Gap Depth 0.39" / 10 mm
Flux Density 1.0 Tesla
Coil Winding Height 0.70" / 18 mm
Voice Coil Diameter 2.5" / 63.5 mm
Speaker Type Bass / Mid Range Driver
Speaker Series The Sovereign Series
Program Power 600 W (A.E.S.)
Sensitivity (1W / 1m) Working band
Thiele Small Parameters (TSPs)
FS 58 Hz
Re 5.7 Ω
QMS 6.08
QES 0.33
QTS 0.313
Vas 41 Litres
Vd 0.208 Litres
CMS 0.211 mm/N
BL 15.3 T/m
MMS 37 grams
Xmax 5.5 mm
Sd 378 cm2
Efficiency 2.36%
Le 1.68 mH
EBP 175.76 Hz
Materials of Construction
Coil Former Material Glass Fibre
Voice Coil Material Copper - Inside / Outside Windings
Magnet Material Ferrite
Chassis Material Pressed Steel
Cone Material Curvilinear Paper
Surround / Edge Termination Polyvinyl Damped Multi Roll. Poly Cotton
Dust Dome Material Paper
Connectors Solder Tag
Polarity Positive voltage at red terminal causes forward motion of cone
Mounting / Shipping Information
Overall Diameter 10.15" / 257.81 mm
Width Across Flats N/A
Flange Height 0.27" / 6.9 mm
Baffle Hole Diameter F/M 9.21" / 233.93 mm
Baffle Hole Diameter R/M 9.21" / 233.93 mm
Gasket Supplied Front & Rear
Outer Fixing Holes 4x ø 6.5 mm on 9.72" / 246.88 mm PCD
Inner Fixing Holes Not Applicable
Depth 4.44" / 112.77 mm
Weight 10.80 lb / 4.9 Kg
Recommended Enclosure Volume 0.88 - 1.76 cu ft / 25 - 50 Litres
Shipping Weight 11.90 lb / 5.4 Kg
Packing Carton Dimensions (W) 275 (D) 275 (H) 150 mm
Sound good but abit heavy
ReviewerAndy P / FromEngland / Date17 Jul 2014
Put two of these in to kustom 2x10 to take it up to 600w at 4ohm, they sound great, very thomann punchy with plenty of low end and a lot of clarity in the high mids, they definitely need to be put in a ported cab for the best results. The only down side is that the cab now weighs a lot more, so if weight is an issue thomann there probably not the best speakers for you, but worth it for the increase in power! Definitely recommend them as a upgrade to any 2x10 due to there great price and the fact that they sound a awesome!
DescriptionSizeFormatGet File
Fane Sovereign 10-300 Datasheet0.36Mb.pdfDOWNLOAD
Stay connected. Get fresh content from Fane to your email box
© 2016 Fane International Limited. All rights Reserved. Site developed by Edoru web design Wakefield
You've reached the maximum comparison limit of four products.
Please choose one of the following options....