Fane Sovereign Pro 15-600N Fane Sovereign Pro 15-600N
TFane Sovereign Pro 15-600N TFane Sovereign Pro 15-600N

SOVEREIGN PRO 15-600N

Bass Driver

Data Sheet
(0 Reviews)  Review this item
£POA
RRP Inc. VAT
AVAILABILITY : OUT OF STOCK

SPECIAL ORDER ONLY. MINIMUM ORDER QUANTITY APPLIES.
Please contact info@fane-international.com for order information.
  • Lightweight neodymium magnet assembly.
  • Weighs only 5.2 kg.
  • Highly versatile in 2-way ported enclosures.
  • UK manufactured cone with optimised pulp offering increased strength, durability and performance.

The Sovereign Pro 15-600N is intended for use in high power two-way ported enclosures and as a high-output bass driver in multi way systems. It features a 3 inch 'sandwich' inside and outside windings voice coil immersed in a symmetric magnetic field yielding increased linearity and lower distortion at high excursion levels. The driver handles 600 Watts (A.E.S) continuous and can cope with peaks in excess of 2400 Watts. This is due to advanced thermal management in the form of vented die-cast chassis and increased motor system venting. These measures effectively remove heat from the voice coil, resulting in extremely low-power compression. The sovereign Pro 15-600N exhibits an average sensitivity of 99 dB and can deliver bass down to 40 Hz (-6 dB) in a 125 Litre ported enclosure.

 

  • Please enquire about alternative impedances.
  • A.E.S. power handling test. Pink noise bandpass filtered at 12 dB per octave with cutoff frequencies of 40 Hz and 400 Hz. Driver mounted in free air, test signal applied at rated power for two hours.
  • Please note that the frequency response measurements are supplied for comparison only and are not a measure of the low frequency performance which may be achieved in a fully optimised system.
Electro Acoustic Specifications
Nominal Chassis Diameter 15" / 381 mm
Impedance 8 Ω
Power Handling 600 W (A.E.S.)
Peak Power (6dB Crest Factor) 2400 W (A.E.S.)
Usable Frequency Range (-6dB) 40 Hz - 4.5 kHz
Sensitivity (1W - 1m) Wideband 99 dB
Moving Mass (inc. Air Load) 82 grams
Minimum Impedance (Zmin) 6.5 Ω
Effective Piston Diameter 13.03" / 330.96 mm
Magnet Weight N/a
Magnetic Gap Depth 0.39" / 10 mm
Flux Density 1.1 Tesla
Coil Winding Height 0.67" / 17 mm
Voice Coil Diameter 3.0" / 76.2 mm
Speaker Type Bass Driver
Speaker Series The Neodymium Series
Program Power 1200 W (A.E.S.)
Sensitivity (1W / 1m) Working band
Thiele Small Parameters (TSPs)
FS 33 Hz
Re 5.4 Ω
QMS 4.33
QES 0.234
QTS 0.222
Vas 310 Litres
Vd 0.55 Litres
CMS 0.284 mm/N
BL 21.9 T/m
MMS 82 grams
Xmax 6.5 mm
Sd 855 cm2
Efficiency 4.30%
Le 2.56 mH
EBP 141.03 Hz
Materials of Construction
Coil Former Material Glass Fibre
Voice Coil Material CCAW - Inside/ Outside Windings
Magnet Material Neodymium
Chassis Material Die-cast Aluminium
Cone Material Curvilinear Polycellulose
Surround / Edge Termination Polyvinyl Damped Dbl. Half Roll Poly Cotton
Dust Dome Material Solid Paper
Connectors Push-button Spring Terminals
Polarity Positive voltage at red terminal causes forward motion of cone
Mounting / Shipping Information
Overall Diameter 16" / 406.4 mm
Width Across Flats 15.25" / 387.4 mm
Flange Height 0.305" / 7.8 mm
Baffle Hole Diameter F/M 13.85" / 351.79 mm
Baffle Hole Diameter R/M 14" / 355.6 mm
Gasket Supplied Front & Rear
Outer Fixing Holes 4x ø 0.281" on 15.5" PCD / 4x ø 7.1 mm on 393.7 mm PCD
Inner Fixing Holes 8x ø 0.281" on 14.56" PCD / 8x ø 7.1 mm on 370 mm PCD
Depth 7.13" / 174 mm
Weight 11.46 lb / 5.2 Kg
Recommended Enclosure Volume 2.26 - 4.41 cu ft / 65 - 125 Litres
Shipping Weight 12.45 lb / 7.2 Kg
Packing Carton Dimensions (W) 410 (D) 410 (H) 210 mm
DescriptionSizeFormatGet File
Fane Sovereign Pro 15-600N Datasheet0.29Mb.pdfDOWNLOAD
Stay connected. Get fresh content from Fane to your email box
SUBSCRIBE
© 2016 Fane International Limited. All rights Reserved. Site developed by Edoru web design Wakefield
PRODUCT COMPARISON
You've reached the maximum comparison limit of four products.
Please choose one of the following options....
VIEW COMPARISIONS