Fane Sovereign 12-200LT Fane Sovereign 12-200LT
TFane Sovereign 12-200LT TFane Sovereign 12-200LT


Full Range Driver

Data Sheet
(0 Reviews)  Review this item

Please contact for order information.
  • Medium-power driver suited for full range output in compact PA systems.
  • Twin cone model offering extended frequency range.
  • Optimised cone pulp offering increased strength, durability and performance.
  • Please enquire about alternative impedances.
  • A.E.S. power handling test. Pink noise bandpass filtered at 12 dB per octave. Driver mounted in free air, test signal applied at rated power for 2 hours.
  • Please note that the frequency response measurements are supplied for comparison only and are not a measure of the low frequency performance which may be achieved in a fully optimised system.
Electro Acoustic Specifications
Nominal Chassis Diameter 12" / 304.8 mm
Impedance 8 Ω
Power Handling 200 W (A.E.S.)
Peak Power (6dB Crest Factor) 800 W (A.E.S.)
Usable Frequency Range (-6dB) 45 Hz - 10 kHz
Sensitivity (1W - 1m) Wideband 98 dB
Moving Mass (inc. Air Load) 52 grams
Minimum Impedance (Zmin) 7.4 Ω
Effective Piston Diameter 10.31" / 261.87 mm
Magnet Weight 56 oz
Magnetic Gap Depth 0.31" / 7.87 mm
Flux Density 1.0 Tesla
Coil Winding Height 0.43" / 10.92 mm
Voice Coil Diameter 2.0" / 50.8 mm
Speaker Type Full Range Driver
Speaker Series The Sovereign Series
Program Power 400 W (A.E.S.)
Sensitivity (1W / 1m) Working band
Thiele Small Parameters (TSPs)
FS 50 Hz
Re 7.2 Ω
QMS 7.6
QES 0.72
QTS 0.64
Vas 78.06 Litres
Vd 0.165 Litres
CMS 0.195 mm/N
BL 13 T/m
MMS 52 grams
Xmax 5.25 mm
Sd 530.9 cm2
Efficiency 1.30%
Le 1.56 mH
EBP 69.44 Hz
Materials of Construction
Coil Former Material Glass Fibre
Voice Coil Material Copper Clad Aluminium Wire
Magnet Material Ferrite
Chassis Material Pressed Steel
Cone Material Paper
Surround / Edge Termination Polyvinyl Damped Dbl. Half Roll Linen
Dust Dome Material Paper
Connectors Solder Tag
Polarity Positive voltage at red terminal causes forward motion of cone
Mounting / Shipping Information
Overall Diameter 12" / 304.8 mm
Width Across Flats N/A
Flange Height 0.27" / 6.9 mm
Baffle Hole Diameter F/M 11.25" / 285.75 mm
Baffle Hole Diameter R/M 11.25" / 285.75 mm
Gasket Supplied Front & Rear
Outer Fixing Holes 8x ø 7.0 mm on 11.75" / 298 mm PCD
Inner Fixing Holes Not Applicable
Depth 5.43" / 137.92 mm
Weight 9.47 lb / 4.3 Kg
Recommended Enclosure Volume 1.05 - 2.64 cu ft / 30 -75 Litres
Shipping Weight 11.24 lb / 5.1 Kg
Packing Carton Dimensions (W) 330 (D) 330 (H) 170 mm
DescriptionSizeFormatGet File
Fane Sovereign 12-200LT Datasheet0.28Mb.pdfDOWNLOAD
Stay connected. Get fresh content from Fane to your email box
© 2016 Fane International Limited. All rights Reserved. Site developed by Edoru web design Wakefield
You've reached the maximum comparison limit of four products.
Please choose one of the following options....