Fane Colossus 12MBN Fane Colossus 12MBN
TFane Colossus 12MBN TFane Colossus 12MBN

COLOSSUS 12MBN

Bass / Mid Range Driver

Data Sheet
(0 Reviews)  Review this item
£POA
RRP Inc. VAT
AVAILABILITY : OUT OF STOCK
  • 1000 W Program Power.
  • 98.5 dB Sensitivity (1W/1m).
  • Weighs only 4.3Kg thanks to a lightweight neodymium magnet motor assembly.
  • Optimised non-inductive motor system efficiently controls magnetic flux and reduces third-harmonic and intermodulation distortion.
  • Excels when deployed in line array applications for fast, dynamic and punchy bass.
  • Extended frequency range working up to 4 kHz.
  • Aluminium demodulation and copper shorting Rings.
  • UK manufactured cone with optimised pulp offering increased strength, durability and performance.
  • Intended as a high-output mid-bass driver in two-way ported enclosures of 25-80 Litres.
  • Also performs well as a bass driver in multi-way systems.
  • 3-inch Inside/ outside windings aluminium voice coil.

The Colossus 12MBN is intended for use as a very high-output bass mid driver in two-way ported enclosures and also as a bass driver in multi way systems. The unit features a 3 inch 'sandwich' inside and outside windings voice coil driven by a Neodymium non inductive motor system which dramatically reduces third-harmonic and intermodulation distortion. The cone membrane, manufactured from polycellulose, is much stronger and more durable than conventional paper pulp alternatives. This allows the driver to combine high-sensitivity with the structural integrity required to produce undistorted low frequencies at high output levels. The mechanical and electrical properties of the unit have been carefully optimised to allow extended low frequency output up to its rated power handling of 500 Watts (A.E.S) continuous, with peak power handling in excess of 2000 Watts. The driver exhibits an average sensitivity of 98.5 dB and is best used in ported enclosures of 25 to 80 Litres.

 

  • Please enquire about alternative impedances.
  • A.E.S. power handling test. Pink noise bandpass filtered at 12 dB per octave with cutoff frequencies of 50 Hz and 500 Hz. Driver mounted in free air, test signal applied at rated power for two hours.
  • Please note that the frequency response measurements are supplied for comparison only and are not a measure of the low frequency performance which may be achieved in a fully optimised system.
Electro Acoustic Specifications
Nominal Chassis Diameter 12" / 304.8 mm
Impedance 8 Ω
Power Handling 500 W (A.E.S.)
Peak Power (6dB Crest Factor) 2000 W (A.E.S.)
Usable Frequency Range (-6dB) 40 Hz - 4 kHz
Sensitivity (1W - 1m) Wideband 98.5 dB
Moving Mass (inc. Air Load) 59 grams
Minimum Impedance (Zmin) 7.5 Ω
Effective Piston Diameter 10.24" / 260.09 mm
Magnet Weight N/a
Magnetic Gap Depth 0.39" / 10 mm
Flux Density 1.1 Tesla
Coil Winding Height 0.70" / 18 mm
Voice Coil Diameter 3.0" / 76.2 mm
Speaker Type Bass / Mid Range Driver
Speaker Series The Neodymium Series
Program Power 1000 W (A.E.S)
Sensitivity (1W / 1m) Working band
Thiele Small Parameters (TSPs)
FS 55 Hz
Re 5.5 Ω
QMS 4.13
QES 0.438
QTS 0.396
Vas 56 Litres
Vd 0.296 Litres
CMS 0.142 mm/N
BL 16.6 T/m
MMS 59 grams
Xmax 5.5 mm
Sd 530 cm2
Efficiency 2.30%
Le 1.39 mH
EBP 125.57 Hz
Materials of Construction
Coil Former Material Glass Fibre
Voice Coil Material Aluminium - Inside / Outside Windings
Magnet Material Neodymium
Chassis Material Die-cast Aluminium
Cone Material Curvilinear Paper
Surround / Edge Termination Polyvinyl Damped Multi Roll. Poly Cotton
Dust Dome Material Solid Paper
Connectors Push-button Spring Terminals
Polarity Positive voltage at red terminal causes forward motion of cone
Mounting / Shipping Information
Overall Diameter 13" / 330.2 mm
Width Across Flats 12.19" / 309.62 mm
Flange Height 0.305" / 7.8 mm
Baffle Hole Diameter F/M 11.03" / 280.16 mm
Baffle Hole Diameter R/M 10.13" / 257.30 mm
Gasket Supplied Front & Rear
Outer Fixing Holes 4x ø 0.218" on 12.5" PCD / 4x ø 5.5 mm on 317.5 mm PCD
Inner Fixing Holes Not Applicable
Depth 5.53" / 140.6 mm
Weight 9.47 lb / 4.3 Kg
Recommended Enclosure Volume 0.88 - 2.83 cu ft / 25 - 80 Litres
Shipping Weight 11.68 lb / 5.3 Kg
Packing Carton Dimensions (W) 330 (D) 330 (H) 170 mm
DescriptionSizeFormatGet File
Fane Colossus 12MBN Datasheet0.16Mb.pdfDOWNLOAD
Stay connected. Get fresh content from Fane to your email box
SUBSCRIBE
© 2016 Fane International Limited. All rights Reserved. Site developed by Edoru web design Wakefield
PRODUCT COMPARISON
You've reached the maximum comparison limit of four products.
Please choose one of the following options....
VIEW COMPARISIONS